Goture Carbon Fiber Telescopic Fishing Rod Ultra-light Stream Hand Pole Carp Feeder Fishing Pole 3.0-7.2M
Basic information:
Feature:
Kind note:
1.We will send the front 3 sections for each fishing rod.
2.The data are measured manually and there may be a little difference.
Here are some tips for pole fishing, if any other problem, please contact with us.~~~
1. Simplicity of a pole fishing
Hera rods are designed to use without a reel
How simple it could be:
Only rod, line, float, weight and hook are used.
The line is tied to the rod at its tip using the overhand knot on the braid lilian material.
Add a line stopper, leaving a 1/8 – 1/4 inch tag to stick out, then girth-hitch a small braid loop on the line between the tip and a stopper.
Connect a float to the line attaching it with simple rubber stoppers, put weight between the float and the hook to place the float scale down to the right deep position.
The float rigs used are similar to ones used on a rod and reel.
The attached float rig hangs from the pole tip and is accurately pushed out over and into the water.
The length of line between the float and the pole tip can vary in length for the type of fishing you want to do.
That's it, that's all it takes.
2. How to Attach the line to a Fishing Pole?
1. A single overhand loop on the braid lilian material connected to the pole's tip is all you need.
2. Next make a double knot on the fishing line.
3. After that put the loop over the braid lilian between the pole tip and the single overhand loop and tide the line.
3. How to attach the float to the line?
Rubber float stop is used to keep a float with a guiding line. Every rubber stopor has a certain size that fit with the guiding line.
4. How to roll wooden fish sinker around line?
Winding tissue paper or cotton thread around fixed part of the weight.
Crease with a scissor. The width of the crease is around 1.0mm – 1.5mm.
Put guiding fish line in the fold.
Fold it closely by your thum to the roll up tightly and to make “Tune Circle”. If you do not fold it closely enough it would be flat shape.
Roll it on a flat surface. If it look “Flat”, roll it on flat surface with pushing of hand hood. It help to shape up.
5. How to connect line with Haris using a swivel?
To prevent 'Interwined”, use smaller swivel. Tie guiding line with swivel by clind knot or uni knot. Then set haris. It is always better to use hook connected with haris first. You need to change the haris constantly to get a better result.
6. Opening and Closing Telescopic Carbon Pole
